Microsoft Networking - Xerox WorkCentre 5022 User Manual

Environment Settings
- SNMP Version:
You can specify the SNMP version for entry as v1 or v2c. (Default: SNMP v1)
- Trap Community Name:
You can enter the trap community name for entry (between 1 and 32 ASCII code characters).
(Default: SNMP_trap)
- Trap to be Received:
You can set whether to send notification of Print, Cold Start and Authentication Failure
events.
• Delete button
You can delete the traps specified for the trap notification recipient IP address by pressing this
button.
• Edit button
You can display notification information of the trap you are using. You can specify the events for
which to send notification.
Apply button
You can apply changes by pressing this button.
Note Reboot the machine to enable new settings.
Microsoft Networking (Connectivity > Protocols)
You can set the SMB protocol and WINS server.
Filing Destination
• SMB Port Status
You can check Enabled to use SMB. (Default: On)
• Physical Connection
Ethernet is displayed.
• Transport
TCP/IP is displayed.
Server Information (WINS Server)
Note Displays when IP Mode is set to IPv4 or Dual Stack.
• Protocol
Displays Enabled.
• Obtain WINS Server Address Automatically
You can check this checkbox to acquire the WINS server address automatically using DHCP. When
you set the WINS server address acquisition method to DHCP, you must also set the IP address
acquisition method to DHCP. (Default: ON)
2-26 ® ®
Xerox WorkCentre 5022/5024 Multifunction Printer
User Guide