X13, Control Voltage (24V, 0V) - Bosch Rexroth IndraDrive HMV Project Planning Manual

Project Planning Manual | Rexroth IndraDrive
connecting line
stranded wire
tightening torque
HCS03.1E-W0100, -W0150
connecting line
stranded wire
tightening torque
HCS03.1E-W0210
connecting line
stranded wire
tightening torque
HCS03.1E
voltage load
short circuit protection
Notes on Installation
CAUTION
8.9

X13, Control Voltage (24V, 0V)

Function, Pin Assignment
Assignment
Spring terminal (connector)
mm
2
AWG
Nm
mm 2
AWG
Nm
mm 2
AWG
Nm
V
to be ensured by means of appropriate fusing elements in the
n.s. not specified
Fig.8-29: Function, pin assignment
Maximum allowed line length to external braking resistor: 5 m
Twist unshielded lines.
Danger by insufficient installation!
Protect the lines with the appropriate fusing elements in the supply feeder.
For the connecting lines at X9, use at least the cross section of the lines for
mains connection at X3.
The external 24V supply is applied via connection point X13 for
● the power section of the drive controller
● brake control via X6
● the control section of the drive controller with the optional modules, except
for such optional modules (e.g. safety technology S1) which require their
own power supply
Connec‐
tion
4
3
2
1
Unit
Electric Drives | Bosch Rexroth AG
and Controls
Functions and Electrical Connection Points
16
6
1,5
25
4
2,0
50
0
8,0
n.s.
mains connection at X3
Signal name
+24V power supply and "looping
+24V
0V reference potential for power
supply and "looping through"
0V
Min.
265/369
1,7
2,5
9,0
Function
through"
Max.