Bosch Rexroth IndraDrive HMV Project Planning Manual page 292

282/369 Bosch Rexroth AG | Electric Drives
Functions and Electrical Connection Points
View
Screw connection
M6 thread at device (terminal block)
tightening torque
short circuit protection
overload protection
current carrying capacity "looping through" from L+ to L+, L- to L-
(contact bars in scope of supply of accessory HAS01)
with contact bars -072
additionally with contact bars ‑042 and end piece
Notes on Installation
and Controls
Identifica‐
tion
L+
L-
Unit
Nm
A
A
Fig.8-57: Function, pin assignment, properties
Fig.8-58: Contact bars
If in special cases it is not possible to use the contact bars provided to establish
the connection, the connection must be established using the shortest possible
(2 × 2 m, as a maximum) and twisted wires.
Rexroth IndraDrive | Project Planning Manual
Function
connections to connect the DC bus connections
Min.
5,5
via fusing elements connected in the incoming circuit to the
mains connection
via fusing elements connected in the incoming circuit to the
mains connection
Max.
6,5
220
245