Bosch Rexroth IndraDrive HMV Project Planning Manual page 102

92/369 Bosch Rexroth AG | Electric Drives
Power Sections for Converters - IndraDrive C
Description
DC bus power at U ;
LN_nenn
T ≤ T ; t = 60 s; T = 10 min;
a a_work
K = 1.1; without mains choke
DC bus power at U ;
LN_nenn
T ≤ T ; t = 60 s; T = 10 min;
a a_max
K = 1,1; with mains choke
16)
Performance Profile "UEL_P_e"
performance profile "UEL_P_e"
Selecting Standard Motors
and Controls
Symbol Unit
P
kW
DC_base_5
15)
P
kW
DC_base_5
1) 2) 3) 4) 5) 6) see definition profile UEL_P_e
7) 8) 9) 10)
11) 12) 13)
14) 15) 16)
Fig.5-74: HCS - Examples of allowed performance profiles
The following performance profiles have been defined for converters and in‐
verters.
Observe the allowed performance data P
corresponding performance profile of the supply unit or converter.
Profile
Fig.5-75: Definition of performance profiles, infeeding supply units and converters
Operation With Standard Motors
General Information
The tables below show the nominal powers P
be operated at the respective drive controller. The data are subject to the fol‐
lowing conditions:
● motor design:
4-pole standard motor (2 pole pairs) with rated voltage 3 AC 400 V, 50 Hz
at mains voltage U
4-pole standard motor (2 pole pairs) with rated voltage 3 AC 460 V, 60 Hz
at mains voltage U
● assigned mains choke is used
● operation at minimum switching frequency f
● rotary field at output with f
Rexroth IndraDrive | Project Planning Manual
HCS03.1E- HCS03.1E-
W0070-_-05 W0100-_-05
12,16 22,03
23,41 39,46
Explanation
Characteristic of the selection of standard motors
and servo drives.
≥ 3 AC 400 V or
LN
≥ 3 AC 460 V
LN
>f
out out_still
HCS03.1E- HCS03.1E-
W0150-_-05 W0210-_-05
32,10 44,24
52,86 80,00
and P
DC_peak DC_base
of standard motors which can
nenn
= f (min.)
s s
in the