Mitsubishi Electric MELSERVO-J5 MR-J5 Series User Manual page 174

■Details on [Touch probe function 2 (Obj. 2DE8h)]
Bit Description
0 0: Touch probe 3 disabled
1: Touch probe 3 enabled
1 0: Single trigger mode
1: Continuous trigger mode
2 0: Triggered by inputting touch probe 3
1: Triggered at the zero point of the encoder
3 (reserved) The value at reading is undefined. Set "0" when writing.
4 0: Stop sampling the rising edge of touch probe 3
1: Start sampling the rising edge of touch probe 3
If input of touch probe 3 is set as a trigger (bit 2 = 0), the position feedback latched at the rising edge of touch probe 3 is stored in [Touch
probe 3 positive edge (Obj. 2DEAh)].
If the zero point of the encoder is set as a trigger (bit 2 = 1), the position feedback at passing the zero point of the encoder
[Touch probe 3 positive edge (Obj. 2DEAh)].
5 0: Stop sampling the falling edge of touch probe 3
1: Start sampling the falling edge of touch probe 3
If input of touch probe 3 is set as a trigger (bit 2 = 0), the position feedback latched at the falling edge of touch probe 3 is stored in [Touch
probe 3 negative edge (Obj. 2DEBh)].
If the zero point of the encoder is set as a trigger (bit 2 = 1), the position feedback at passing the zero point of the encoder
[Touch probe 3 negative edge (Obj. 2DEBh)].
6 (reserved) The value at reading is undefined. Set "0" when writing.
7
8 to 15
*1 For linear servo motors, the zero point of the encoder is a position between homing stop intervals [pulse] (changeable with [Pr. PL01.2
Homing stop interval setting]) based on the linear encoder home position.
4 APPLICABLE FUNCTIONS
172
4.4 Touch probe
*1
is stored in
*1
is stored in