Mitsubishi Electric MELSERVO-J5 MR-J5 Series User Manual page 14

I/O, monitor
Functions Detailed functions
DI/DO Input signal selection (device
selection)
Output signal selection (device
setting)
A/B/Z-phase output
Analog input/output Analog monitor
Monitor Power monitoring function
Touch probe Current position latch function
Option
Functions Detailed functions
Regenerative Regenerative option
capacity
enhancement
1 FUNCTION
12
1.1 Function explanation
Description
This function assigns input devices such as LSP
(Forward rotation stroke end) to certain pins of
the connector.
This function assigns output devices such as
MBR (Electromagnetic brake interlock) to certain
pins of the connector.
This function outputs the positions of the encoder
and linear encoder in the A/B/Z-phase signal.
This function outputs the servo status in voltage
in real time.
This function calculates the running power and
the regenerative power from the data in the servo
amplifier such as speed and current. The power
consumption and other values are displayed on
MR Configurator2.
This function latches the current position when
TPR1 (Touch probe 1), TPR2 (Touch probe 2), or
TPR3 (Touch probe 3) is turned on.
Description
Use this function if the built-in regenerative
resistor of the servo amplifier does not have
sufficient regenerative capacity for the generated
regenerative power.
MR-J5 Detailed explanation
firmware
version
G A
Page 112 Assigning I/
A0 A0
O devices
Page 112 Assigning I/
A0 A0
O devices
Page 272 A/B/Z-phase
A0 A0
pulse output function
Page 293
A0 A0
MONITORING
A0 A0
 Page 167 Touch probe
A5
MR-J5 Detailed explanation
firmware
version
G A
Page 115
A0 A0
Regenerative option
selection