Sm 338; Pos Input - Interrupts - Siemens SIMATIC Manual

Hide thumbs Also See for SIMATIC:

Table of Contents

SM 338; POS INPUT - Interrupts

Introduction

This chapter describes the interrupt reaction of SM 338; POS-INPUT. The SM 338 can

trigger diagnostic interrupts.

For detailed information on the OBs and SFCs mentioned below, refer to the

Enabling interrupts

There is no default interrupt setting, i.e. interrupts are disabled if not set accordingly. You

configure the interrupt enable parameter in

SM 338 POS-INPUT (Page 505)").

Diagnostic interrupt

If you have enabled diagnostic interrupts, the incoming error events (initial occurrence of the

error) and outgoing error events (message after troubleshooting) are reported by means of

The CPU interrupts user program execution, and executes diagnostic interrupt OB82.

You can call SFC 51 or 59 in OB82 in the user program to view detailed diagnostic data

output by the module.

Diagnostics data remain consistent until the program exits OB 82. The module

acknowledges the diagnostic interrupt when the program exits OB82.

S7-300 Module data

Manual, 06/2017, A5E00105505-AJ

7.4 Position decoder module SM 338; POS-INPUT; (6ES7338-4BC01-0AB0)

(refer to chapter "Parametrization

Other signal modules

S7-300S7-300 module data