Siemens SIMATIC Manual page 304

Analog modules
6.2 Module overview
Properties
Measuring range any, per channel
selection group
Supports isochro- Yes
nous mode
Programmable No
diagnostics
Diagnostic inter- programmable
rupt
Limit value moni- programmable for
toring 1 channel
Hardware interrupt Programmable
when limit ex-
ceeded
Hardware interrupt no
at end of cycle
Potential ratios electrically isolated
from:
•
the CPU
•
The load volt-
age (not for 2-
DMU)
≤ DC 2.3 V
maximum potential
difference be-
tween inputs (ICM)
Special features -
Z sign
2-DMU = 2-wire transducer
* This module is described in the Distributed I/O Device ET 200M HART Analog Modules
manual. You can find the manual on the Internet
(http://support.automation.siemens.com/WW/view/en/22063748).
304
any, per channel any, per channel
group group
No Yes
Yes No
Programmable Programmable
Programmable for programmable for
6 channels 8 channels
Programmable Programmable
No Programmable
electrically isolated electrically isolated
from: from:
• •
the CPU of the CPU
250 V AC -
Calibration -
Module
any, per channel
group
Yes
No
Programmable
programmable for
8 channels
Programmable
Programmable
electrically isolated
from:
•
the CPU
-
-
Manual, 06/2017, A5E00105505-AJ
any, per channel
group
Yes
no
Programmable
programmable for
8 channels
programmable
No
electrically isolated
from:
•
the CPU
•
The load volt-
age (not for 2-
DMU)
-
-
S7-300 Module data