Siemens SIMATIC Manual page 151

Technical specifications
Actuator selection data
Output voltage
•
•
Output current
•
•
Output delay (with resistive load)
•
•
Load resistor range
Lamp load
Connecting 2 outputs in parallel
•
•
Control of a digital input
Operating frequency
•
•
•
Limit (internal) of the inductive circuit interrup-
tion voltage to
Short-circuit of an output
•
S7-300 Module data
Manual, 06/2017, A5E00105505-AJ
3.24 Digital output module SM 322; DO 16 x DC 24 V/0.5 A: (6ES7322-8BH10-0AB0)
"1" signal
"0" signal
At signal "1"
Nominal value
Permitted range
"0" signal (residual current)
At "1" to "0"
At "1" to "0"
For redundant triggering of a load
To increase performance
with resistive load
With inductive load, to IEC 947-5-1, DC 13 Max. 2 Hz
With lamp load
Response threshold
Min. L + (- 0.7 V)
0.7 mA * R (R = load resistance value)
L L
max. 31 V for R = infinite
L
0.5 A
5 mA up to 600 mA
Max. 0.7mA
Max. 2.7 ms (including module cycle time)
Max. 2.7 ms (including module cycle time)
48 Ω bis 4kΩ
Max. 5 W
supported
Not possible
supported
Max. 100 Hz
Max. 10 Hz
Typical L+ (-68 V)
Yes, electronic
Typical 1.4 A
Digital modules
151