Siemens SIMATIC Manual page 169

Technical specifications
Actuator selection data
Output voltage
•
"1" signal
– At maximum current
– At minimum current
Output current
•
"1" signal
Rated value
Permitted range at 0 °C to 40 °C
Permitted range at 0°C to 60°C
Maximum inrush current (per group)
•
with "0" signal (residual current)
Blocking voltage
Zero transition
Size of the motor starter
Lamp load
Wiring two outputs in parallel
•
for redundant load control
•
for performance increase
Control of a digital input
Switching frequency
•
with resistive load
•
with inductive load to IEC 947-5-1, AC 15
•
with lamp load
Short-circuit protection of the output
•
Fuse-tripping current
•
Response time
Replacement fuses
•
Wickman
•
Schurter
•
Littlefuse
Fuse holder
•
Wickman
Wiring of the actuators
S7-300 Module data
Manual, 06/2017, A5E00105505-AJ
3.27 Digital output module SM 322; DO 16 x AC 120/230 V/1 A; (6ES7322-1FH00-0AA0)
min. L 1 (- 1.5 V)
min. L 1 (- 8.5 V)
1 A
10 mA to 1 A
10 mA to 0.5 A
20 A (two half-waves)
max. 2 mA
max. 60 V
max. size 4 to NEMA
max. 50 W
supported (only outputs of the same group)
no
supported
max. 10 Hz
max. 0.5 Hz
max. 1 Hz
Fuse 8 A,
250 V; per group
min. 40 A
max. 300 ms
8 A fuse, fast-blowing
19 194-8 A
SP001.1014
217.008
19 653
using a 20-pin front connector
Digital modules
169