Siemens SIMATIC Manual page 124

Digital modules
3.19 Digital output module SM 322; DO 64 x DC 24 V/0.3 A sourcing; (6ES7322-1BP00-0AA0)
Technical specifications
Status, interrupts, diagnostics
Status display
Interrupts
Diagnostic functions
Actuator selection data
Output type
Output voltage
•
"1" signal
Output current
•
"1" signal
– Rated value
– Permitted range
•
"0" signal (residual current)
Output delay (resistive load)
•
"0" to "1" transition
•
"1" to "0" transition
Load resistance range
Lamp load
Wiring two outputs in parallel
•
For redundant load control
•
For performance increase
Control of a digital input
Switching frequency
•
with resistive load
•
With inductive load to IEC 947-5-1, DC 13
•
With lamp load
Internal limiting of the inductive shutdown voltage to:
Short-circuit-proof output
•
Response threshold:
Wiring of the actuators
1
For loads above 200 mA, a terminal diode is required for the inductive load
STEP 7 integration
64-channel I/O modules are integrated with the HSP 2019 V 1.0. The HSP forms part of
STEP 7 V 5.4 SP2 and can be installed from STEP 7 V 5.4 and higher.
124
Green LED per channel
None
None
M switching
24 V DC
L+ (-0.5 V)
Typ. 0.3 A
2.4 mA to 0.36 A
<100 µA
<550 µs
<550 µs
80 Ω to 10 kΩ
Max. <5 W
supported (with external diode)
not supported
supported
Max. <100 Hz
Max. <0.5 Hz
1
Max. <10 Hz
53 V typ.
Yes, electronic
0.7 A to 1.9 A typ.
Two 40-pin terminal blocks
.
Manual, 06/2017, A5E00105505-AJ
S7-300 Module data