Siemens SIMATIC Manual page 464

Analog modules
6.14 Analog output module SM 332; AO 4 x 12 Bit; (6ES7332-5HD01-0AB0)
Technical specifications
Interference frequency suppression, error limits
Crosstalk between outputs
Operational limit (across entire temperature range, relative to measurement range end value in the selected output range)
•
Voltage output
•
Current output
Basic error limit (operational limit at 25 °C, relative to the measurement range end value in the selected output range)
•
Voltage output
•
Current output
Temperature error (relative to output range)
Linearity error (relative to output range)
Repeat accuracy (in settled state at 25 °C, relative to output range)
Output ripple; range 0 Hz to 50 kHz (relative to output range)
Status, interrupts, diagnostics
Interrupts
•
Diagnostic interrupt
Diagnostic functions
•
Group fault display
•
Reading diagnostic information
Setting substitute values
Actuator selection data
Output ranges (rated values)
•
Voltage
•
Current
Load impedance (in the rated range of the output)
•
For voltage outputs
– Capacitive load
•
For current outputs
– at CMV < 1 V
– inductive load
Voltage output
•
Short-circuit protection
•
Short-circuit current
Current output
•
noload voltage
464
> 40 dB
± 0.5 %
± 0.6 %
± 0.4 %
± 0.5 %
± 0.002 %/K
± 0.05 %
± 0.05 %
± 0.05 %
Programmable
programmable
Red LED (SF)
Supported
Yes, programmable
± 10 V
0 V to 10 V
1 V to 5 V
± 20 mA
0 mA to 20 mA
4 mA to 20 mA
Min. 1 kΩ
Max. 1 µF
max. 500 Ω
max. 600 Ω
max. 10 mH
Yes
max. 25 mA
max. 18 V
Manual, 06/2017, A5E00105505-AJ
S7-300 Module data