Switching Mymodes Using Motion Patterns - Otto Bock 1B1-2 Meridium Instructions For Use Manual

Product
2. Golf
1. Basic Mode
1
2
3
100% 1. Basic Mode

8.3.2 Switching MyModes using motion patterns

INFORMATION
If the Volume parameter is set to '0' in the Cockpit app or using the remote control, there are
no beep signals (see Page 69).
Information on switching
• Switching and the number of motion patterns must be activated in the adjustment software.
• Before further activities, always check whether the selected mode corresponds to the
required motion type.
Switching process
1) Hold the prosthetic leg under the body.
2) Using the heel of the prosthetic foot, knock on a solid obstacle behind you (e.g. a wall)
according to the number of the configured MyMode (MyMode 1 = 3 times, MyMode 2 = 4
times, MyMode 3 = 5 times). It is also possible to knock against the tip of the shoe of the con­
tralateral leg.
→ A beep and vibration signal will occur to confirm that the movement pattern has been
recognised.
INFORMATION: If this beep and vibration signal is not emitted, the requirements
were not met while bouncing.
3) Lean the prosthetic foot slightly to the back and place weight on the forefoot.
INFORMATION: If the prosthetic foot is strongly dorsiflexed, weight can be placed on
the heel.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched
to the corresponding mode (2 times = MyMode 1, 3 times = MyMode 2, 4 times =
MyMode 3).
INFORMATION: If this confirmation signal does not occur, weight was not placed
on the prosthetic foot correctly or not for enough time. Repeat the process to cor­
rectly switch to the required mode.
4) Remove the load from the prosthetic leg.
→ The mode has been changed.
1) Tap the symbol of the MyMode (1) you want in the main
menu of the app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the act­
ive mode.
→ The current mode is also indicated by the name on the
lower edge of the screen (3).
67