Switching Mymodes Using Motion Patterns; Switching From A Mymode Back To Basic Mode - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

9.2.3 Switching MyModes using motion patterns

Information on switching
• Switching and the number of motion patterns must be activated in the adjustment software.
• Before the first step, always check whether the selected mode corresponds to the required
motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
• Switching using motion patterns has to be enabled in the adjustment software.
• Stretch out the prosthetic leg to the back and bounce on the forefoot while maintaining con­
tact with the floor.
Switching process
1) Within a second, bounce the forefoot the number of times that corresponds with the MyMode
you want (MyMode 1 = 3x, MyMode 2 = 4x).
→ A beep signal will sound to confirm that the motion pattern has been recognised.
2) Move the prosthetic leg in next to the contralateral leg, set it down and keep it still for approx.
1 second.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched to
the corresponding mode (2x = MyMode 1, 3x = MyMode 2).
INFORMATION: If this confirmation signal does not sound, the leg with the prosthesis
was not correctly repositioned next to the contralateral leg or the requirements were
not observed when bouncing the foot. Repeat the process to correctly switch to the
desired mode.

9.2.4 Switching from a MyMode back to basic mode

Information on switching
• Regardless of the configuration of additional MyModes in the adjustment software, it is always
possible to switch back to basic mode (mode 1) with a motion pattern.
• It is always possible to switch back to basic mode (mode 1) by connecting/disconnecting the
battery charger.
80 | Ottobock
1) Tap the symbol of the MyMode (1) you want in the main
menu of the app.
→ A security question for changing the MyMode appears.
2) If you want to change the mode, tap the "OK" button.
→ A beep signal will sound to confirm the switch. The cur­
rent mode is also displayed as a symbol on the lower
edge of the screen (2).