Status Display In The Cockpit App; Status Information On The Display Of The Remote Control (Optional Accessory); Additional Operating States (Modes); Empty Battery Mode - Otto Bock 1B1-2 Meridium Instructions For Use Manual

8.6.2 Status display in the cockpit app

Menu option
Trip: 1747
Step: 1747
Batt.: 68

8.6.3 Status information on the display of the remote control (optional accessory)

Menu option
Trip:1747
Step:1747
Batt.:68
Bluetooth: On

9 Additional operating states (modes)

9.1 Empty battery mode

Beeps and vibration signals are emitted if the available battery charge level drops to 0% (see
Page 77). During this time, damping settings are set to their safety mode values. The prosthesis is
then switched off. You can switch back to basic mode (mode 1) from empty battery mode by
charging the product.

9.2 Mode for charging the prosthesis

The ankle joint of the prosthetic foot is locked during the charging process.

9.3 Safety mode

The product automatically switches to safety mode if a critical system error occurs (e.g. failure of
a sensor signal) or when the battery is empty. Safety mode remains in effect until the error has
been rectified.
Default damping values are activated in safety mode. This makes limited walking possible for the
user even though the system is not active.
The switch to safety mode is indicated by beeps and vibration signals immediately prior to switch­
ing (see Page 77).
Safety mode can be disabled by connecting then disconnecting the battery charger. If the
product switches into safety mode again, this means a permanent error exists. The product must
be inspected by an authorised Ottobock Service Centre.

9.4 Overheating mode

When the hydraulic unit overheats due to uninterrupted, increased activity (e.g. extended walking
downhill), damping is increased along with the rising temperature in order to counteract the over­
72
Description
Daily step counter
Total step counter
Current prosthesis charge
level, as a percentage
Description
Daily step counter
Total step counter
Current prosthesis charge
level, as a percentage
Switch Bluetooth function of
the prosthesis on or off
Possible actions
Reset the counter by tapping
the "Reset" button.
For informational purposes
only
For informational purposes
only
Possible actions
Reset the counter by using the
key to confirm the menu
option
For informational purposes
only
For informational purposes
only
The Bluetooth function of the
prosthesis can be turned on or
off (see Page 71) by confirm­
ing the menu item with the
key.