Switching Mymodes Using Motion Patterns - Otto Bock Genium X3 3B5-3 Instructions For Use Manual

Hide thumbs Also See for Genium X3 3B5-3:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 53
Product
1. Basic Mode
1
2
3
100%
1. Basic Mode

9.3 Switching MyModes using motion patterns

INFORMATION
When mute mode (silent mode) is activated, no beep and vibration signals are generated.
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app (see page 78) or if mute mode (silent
mode) is activated, there are no beep signals.
Information on switching
Switching and the number of movement patterns must be activated by the O&P professional
in the adjustment software.
Before the first step, always check whether the selected mode corresponds to the required
motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
Switching using movement patterns has to be enabled by the O&P professional.
Position the prosthetic leg back slightly and bounce on the forefoot with the leg extended
while maintaining constant contact with the floor.
Weight must be placed on the forefoot while bouncing.
Do not take the weight off fully during unloading while bouncing.
Switching process
3x
à MyMode 1
4x à MyMode 2
ð
1) Position the prosthetic leg slightly to the rear (step position).
2) While maintaining constant contact with the floor, bounce on the forefoot with the leg exten­
ded a number of times in one second depending on the desired MyMode (MyMode 1 = 3
times, MyMode 2 = 4 times).
3) Fully unload and keep the prosthetic leg still in this position (step position).
1) Tap the symbol of the MyMode (1) you want in the main
menu of the app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
2. Golf
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the act­
ive mode.
→ The current mode is also indicated by the name on the
1x
+
ð
lower edge of the screen (3).
1s
1x
ð ð
2x à MyMode 1
3x à MyMode 2
MyMode 1
+
ð
MyMode 2
þ
85

Advertisement

Table of Contents
loading

This manual is also suitable for:

Genium x3 3b5-3 st

Table of Contents