Otto Bock 1B1-2 Meridium Instructions For Use Manual page 78

Beep signal
10 x short
30 x long
Error while charging the product
LED on LED on bat­
power tery charger
supply
78
Vibration signal
1 x short at interval of
approx. 5 seconds
10 x long
Intermittent for
5 minutes
Error
Country-specific plug adapter not
fully engaged on power supply
Non-functional socket
Defective power supply
No connection between battery
charger and power supply
Defective battery charger
Battery is fully charged (or con­
nection with product is interrup­
ted).
Event
Overheated hydraulic
unit
Battery charge level
at 0%
Switch to safety
mode.
Severe error
e.g. failure of valve
drives
Possibly no switching
into safety mode.
Resolution
Check whether the country-spe­
cific plug adapter is fully
engaged on the power supply.
Check socket with another elec­
tric device.
The battery charger and power
supply must be inspected by an
authorised Ottobock Service
Centre.
Check whether the charging
cable plug is fully engaged on the
battery charger.
The battery charger and power
supply must be inspected by an
authorised Ottobock Service
Centre.
Take note of the confirmation sig­
nal for differentiation.
When the battery charger is con­
nected or disconnected, a self-
test is conducted and confirmed
by a beep and vibration signal.
The battery is fully charged if this
signal is heard.
If no signal is emitted, the con­
Required action
Reduce activity
Charge battery
Restricted walking pos­
sible.
Attempt to reset this error
by connecting/discon­
necting the battery char­
ger.
If the error persists, it is
no longer permissible to
use the product. The
product must be inspec­
ted immediately by a
prosthetist.