Switching Mymodes Using Motion Patterns - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Product
1. Basic Mode 2. Golf
1
2
3
100% 1. Basic Mode

8.2.2 Switching MyModes using motion patterns

Information on switching
• Switching and the number of motion patterns must be activated by the prosthetist in the
adjustment software.
• Before the first step, always check whether the selected mode corresponds to the required
motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
• Switching using motion patterns has to be enabled in the adjustment software.
• Position the prosthetic leg back slightly (lunge position) and bounce on the forefoot while
maintaining constant contact with the floor.
Then keep the prosthetic leg still in this position (lunge position) for about 1 second without
lifting the leg. Taking the weight off is no longer necessary.
Switching process
1) Position the prosthetic leg back slightly (lunge position).
2) While maintaining constant contact with the floor, bounce on the forefoot a number of times in
one second depending on the desired MyMode (MyMode 1 = 3 times, MyMode 2 = 4 times).
3) Keep the prosthetic leg still in this position (lunge position) for about 1 second
without lifting the leg. Taking the weight off is no longer necessary.
→ A beep signal will sound to confirm that the motion pattern has been recognised.
INFORMATION: If this beep signal does not sound, the requirements were not
observed when bouncing the foot.
4) Move the prosthetic leg in next to the contralateral leg, set it down and keep it still for approx.
1 second.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched to
the corresponding MyMode (2 times = MyMode 1, 3 times = MyMode 2).
INFORMATION: If this confirmation signal does not sound, the leg with the prosthesis
was not correctly repositioned and kept still. Repeat the process to correctly switch to
the required mode.
1) Tap the symbol of the MyMode (1) you want in the main
menu of the app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the act­
ive mode.
→ The current mode is also indicated by the symbol and
name on the lower edge of the screen (3).
Ottobock | 57