Switching Mymodes Using Motion Patterns - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Once a connection to a prosthesis has been established, the cockpit app can be used to switch between the
MyModes.
Product
2. Golf
1. Basic Mode
1
2
3
100% 1. Basic Mode

10.2 Switching MyModes using motion patterns

Information on switching
• Switching and the number of motion patterns must be activated in the adjustment software.
• Before the first step, always check whether the selected mode corresponds to the required motion type.
• If the Volume parameter is set to "0" in the Cockpit app, there are no beep signals (see page 39).
Switching process
3x
à MyMode 1
1s
4x à MyMode 2
ð
1) Position the prosthetic leg back slightly.
2) While maintaining constant contact with the floor, bounce on the forefoot a number of times in one second
depending on the desired MyMode (MyMode 1 = 3 times, MyMode 2 = 4 times).
3) Keep the prosthetic leg still in this position (lunge position) for about 1 second without lifting the leg. Taking the
weight off is no longer necessary.
→ A beep and vibration signal will occur to confirm that the movement pattern has been recognised.
INFORMATION: If this beep and vibration signal is not emitted, the requirements were not met
while bouncing.
4) Following the beep and vibration signal, move the prosthetic leg next to the contralateral leg, set it down and
keep still for about 1 second.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched to the corresponding
MyMode (2 times = MyMode 1, 3 times = MyMode 2).
INFORMATION: If this confirmation signal does not sound, the leg with the prosthesis was not cor­
rectly repositioned and kept still. Repeat the process to correctly switch to the required mode.
C-Leg 3C98-3/3C88-3
1) Tap the symbol of the MyMode (1) you want in the main menu of the
app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the active mode.
→ The current mode is also indicated by the name on the lower edge
of the screen (3).
1x 1x
+
ð
1s
ð
ð
2x à MyMode 1
3x à MyMode 2
MyMode 1
+
ð
MyMode 2
MyModes
þ
43