Changing Prosthesis Settings - Otto Bock 1B1-2 Meridium Instructions For Use Manual

→ A beep and vibration signal will occur to confirm that the motion pattern has been recog­
nised.
3) Lean the prosthetic foot slightly to the back and place weight on the forefoot.
INFORMATION: If the prosthetic foot is strongly dorsiflexed, weight can be placed on
the heel.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched
over to basic mode.
INFORMATION: If this confirmation signal does not occur, weight was not placed
on the prosthetic foot correctly or not for enough time. Repeat the process to cor­
rectly switch to the required mode.
4) Remove the load from the prosthetic leg.
→ The mode has been changed.
• Before the first step, always check whether the selected mode corresponds to the required
motion type.

8.4 Changing prosthesis settings

Once an active connection to a prosthesis has been established, the settings of the mode cur­
rently active can be changed using the cockpit app or the remote control (optional accessory).
INFORMATION
Bluetooth on the prosthesis must be switched on to change the prosthesis settings.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. The connection must be established during this period.
Information for changing the prosthesis settings
• Before changing settings, always check the main menu of the cockpit app or the display of
the remote control (optional accessory) to make sure the correct prosthesis has been selec­
ted. Otherwise, parameters could be changed for the wrong prosthesis.
• It is not possible to change prosthesis settings nor to switch to a different mode while the
prosthesis battery is being charged. Only the status of the prosthesis can be called up.
Instead of the
pit app.
• The prosthetist's setting is located in the middle of the scale. After making adjustments, this
setting can be restored by tapping the "Standard" button (Cockpit app) or by moving the
slider control into the middle (remote control).
• Prosthesis settings should be optimised using the adjustment software. The cockpit app or
remote control (optional accessory) is not intended for use by the prosthetist in order to set up
the prosthesis. The behaviour of the prosthesis can be changed to a certain extent on a day-
to-day basis using the remote control or app (e.g. while becoming accustomed to the pros­
thesis). The prosthetist can use the adjustment software to trace these changes at the next
appointment.
• If the settings of a MyMode are to be modified, one must first switch to this MyMode.
symbol, the symbol appears in the bottom row of the screen in the cock­
69