Table of Contents
Advertisement
1GP71_0E
HP8340 emulation mode
Status
Command
DCL
GET
GTL
LLO
REN
SDC
SPD
SPE
SRQ
Commands
The following table shows the commands, supported by the HP8340.
•
Additional
Status
Command / Function / Remark / Limitation
EX
Return to SCPI mode.
Remark:
This command has been added to the HP8340 command set.
Emulation parameters (current register, backup registers) are NOT persistent and
get lost when leaving the emulation mode.
•
Swept / CW Frequency Selection
Status
Command / Function / Remark / Limitation
FA[value]
Function / Remark / Limitation
Device clear.
Goup execute trigger.
Goto local mode.
Local lockout.
Goto remote mode.
Selective device clear.
Serial-Poll disable.
Serial-Poll enable.
Request service.
Remarks:
The status system of the HP8340 is not compatible with the
status system implemented in the SMF100 in accordance
with IEEE 488.2.
The bits in the status byte supported by the emulation
software in the SMF100 are.
Bit 7 – New frequencies or sweep time in effect
o
Bit 6 – Request service
o
Bit 4 – End of sweep
o
The emulations software in the SMF100 sets all othe bits in
status byte to "0".
Table 50: HP8340 GPIB functions
Table 51: Additional commands
58
Rohde & Schwarz
Advertisement
Table of Contents
