Table of Contents
Advertisement
1GP71_0E
HP8662 emulation mode
SP90 value
Set sequence step delay
SP91
Enable generators rapid switching mode.
SP92
Restore knob to 12Inc/Rev
SP93
Allow user defined settings for vernier and attenuator
SP94
Change knob to 120Inc/Rev without AUX reconfiguring
SP95
Change knob to 120Inc/Rev with AUX reconfiguring
SP96
Turn modulation oscillator off.
SP97
Turn modulation oscillator on.
SP98
Turns on readout and annunciators.
SP99
Turns off readout and annunciators.
Instrument initialization
The (factory) default setting of the HP8340 is applied when
applying the DCL, SDC to the GPIB interface.
o
transmitting the first command after activating this emulation mode.
o
During initialisation, the HP8340 applies and activates the backup register set
0.
The SM* however applies and activates the (factory) default setting of the
HP8340.
This different behaviour has to the be taken in consideration:
It is strongly recommended to explicitly setup all necessary parameters
by applying the corresponding command.
The following table shows the (factory) default setting, applied by the SM*'s
emulation software.
Subsystem
Table 157: Special Function
163
Default setting
Rohde & Schwarz
Advertisement
Table of Contents
