Table of Contents
Advertisement
HP8662 emulation mode
Set sweep step size.
Value:
Value in {HZ | KZ | MZ} | UP | DN
Default:
?
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
N4
Set sweep steps to 10 % and sweep spacing to logarithmic.
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
N5
Set sweep steps to 1 % and sweep spacing to logarithmic.
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
T1
Set rf sweep step (dwell) time to 0.5 ms.
T2
Set rf sweep step (dwell) time to 1.0 ms.
T3
Set rf sweep step (dwell) time to 2.0 ms.
T4
Set rf sweep step (dwell) time to 10.0 ms.
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
T5
Set rf sweep step (dwell) time to 100.0 ms.
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
X1 value
Turn marker 1 on, optionally set marker frequency.
X2 value
Turn marker 2 on, optionally set marker frequency.
1GP71_0E
156
Rohde & Schwarz
Advertisement
Table of Contents
