Table of Contents
Advertisement
1GP71_0E
Activation
Possible values for the emulation language depend on the signal generator
familiy.
Emulation language
AF2040
AN680XX
HP8340
HP8360
HP8373
HP8643
HP8648
HP8657
HP8662
RC3102
"SCPI" returns to the instrument specific SCPI command set.
Remote
Use the command notation
"SYSTem:LANGuage <value>" to select the appropriate language emulation
mode.
Upper-case and lower-case notation serves to distinguish between the long
and the short form. The instrument itself does not distinguish between upper-
case and lower-case spelling.
Possible values are shown in table "Emulation modes on SM*".
Power down / Power up
The selected language emulation mode is saved when the instrument is
switched off.
The emulation parameters are NOT persistent and are therefore lost when the
instrument is switched off.
When the instrument is switched on again, it starts up with the language
emulation mode, which was active before switching it off.
Due to the loss of the emulation parameters, it is strongly recommended to
preset the instrument by applying the corresponding preset command, e.g., the
command IP in HP8340 emulation mode.
Table 5: Emulation modes on SM*
13
SMA100
SMB100
X
X
X
X
X
X
X
Rohde & Schwarz
SMF100
X
X
X
X
Advertisement
Table of Contents
