Table of Contents
Advertisement
7.5
Adept PA-4 Power Chassis
Fan Filter Inspection and Cleaning
The air filter located on the front of the chassis should be inspected regularly and cleaned at
the first sign of dust or dirt buildup. The filter must be inspected and cleaned at least once
per month. Regular cleaning will prolong the life of the filter. If the filter becomes clogged
or unusable for any reason, you will need to order a new air filter. The part number for the
filter is: 40330-11190 for chassis Model 3303, 40330-112000 for chassis Model 3306.
WARNING: Dangerous voltages are present inside the power chassis.
Turn off the power to the power chassis and disconnect it from the AC
power source before opening the front grill to inspect the air filter. Failure
to observe this warning could cause injury or damage to your equipment.
1. Turn off the power to the power chassis and disconnect it from the AC power
source.
2. Open the front grill by loosening two screws and swinging the grill out.
3. Pull the air filter out and inspect for dust or dirt particles. If cleaning is required,
use compressed air to clean the filter.
4. Replace the cleaned air filter and secure the grill.
See the Adept MV Controller User's Guide for information on checking the air filter in the
Adept MV controller.
Adept 550 Table-Top Robot User's Guide, Rev A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Adept PA-4 Power Chassis
59
Advertisement
Table of Contents
