Joining At The Top - adept technology 550 User Manual

Joining at the Top

1. Place the two units next to each other. Turn off power to each unit and disconnect
the power. Remove the top cover from both. See Figure 5-2.
2. Locate the C-shaped bracket in the accessory kit.
3. Slip the bracket under the lip of the top edge of the unit on the right-hand side
and into the two slots in the edge of the chassis. Install two M4 x 8 flat head
screws into the lip and down into the bracket.
4. Install the other two M4 x 8 flat head screws into the chassis on the left-hand side.
Replace the cover on each unit.
Adept MV-8 Controller
Joining the Power Chassis and Controller at the Top
Figure 5-2.
Adept 550 Table-Top Robot User's Guide, Rev A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Top view with covers removed
Adept PA-4 Power Chassis
Install four M4 x 8 flat-head
Phillips screws to secure bracket.
Power Chassis Installation
35