Joining At The Bottom - adept technology 550 User Manual

Chapter 5 - Power Chassis Installation

Joining at the Bottom

1. Turn the two units over so you have access to the bottom side.
2. Locate the two cutout brackets in the accessory kit.
3. Place the brackets over the feet of the units as shown in Figure 5-3.
4. Install the four M4 x 8 flat head screws in the holes indicated in Figure 5-3 to
secure the brackets.
Adept MV-8
Controller
Joining the Power Chassis and Controller at the Bottom
Figure 5-3.
36 Adept 550 Table-Top Robot User's Guide, Rev A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Bottom View
Install 2 flat-head Phillips screws
to secure each bracket.
Adept PA-4
Power Chassis