Table of Contents
Advertisement
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the left control panel assembly in the slot on the system.
3. Using the Phillips #1 screwdriver, tighten the screws that secure the left control panel assembly.
4. Using the Phillips #1 screwdriver, tighten the screws to secure the cable cover to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 94. Installing the left control panel
Next steps
1.
Replace the air
shroud.
2.
Install the backplane cover
3. Close and secure the cable guiding latch.
4. Follow the procedure listed in the
Remove the right control panel
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
•
If applicable,
Remove the drive backplane cover
•
Remove the air
shroud.
•
Lift the cable guiding latch.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the cable cover and lift the cover away from the system.
After working inside your
system.
Safety
instructions.
Before you work inside your
system.
Installing and removing system components
121
Advertisement
Table of Contents
