Table of Contents
Advertisement
Table 89. LCD panel features (continued)
Item Button or
display
4
LCD display
Viewing Home screen
The Home screen displays user-configurable information about the system. This screen is displayed during normal system operation when
there are no status messages or errors. When the system turns off and there are no errors, LCD enters the standby mode after five
minutes of inactivity. Press any button on the LCD to turn it on.
Steps
1. To view the Home screen, press one of the three navigation buttons (Select, Left, or Right).
2. To navigate to the Home screen from another menu, complete the following steps:
a. Press and hold the navigation button till the up arrow
b. Navigate to the Home icon
c. Select the Home icon.
d. On the Home screen, press the Select button to enter the main menu.
Setup menu
NOTE:
When you select an option in the Setup menu, you must confirm the option before proceeding to the next action.
Table 90. Setup menu
Option
Description
iDRAC
Select DHCP or Static IP to configure the network mode. If Static IP is selected, the available fields are IP,
Subnet (Sub), and Gateway (Gtw). Select Setup DNS to enable DNS and to view domain addresses. Two
separate DNS entries are available.
Set error
Select SEL to view LCD error messages in a format that matches the IPMI description in the SEL. This enables you
to match an LCD message with an SEL entry.
Select Simple to view LCD error messages in a simplified user-friendly description. For information about the
event and error messages generated by the system firmware and agents that monitor system components, go to
qrl.dell.com
Set home
Select the default information to be displayed on the Home screen. See View menu section for the options and
option items that can be set as the default on the Home screen.
View menu
NOTE:
When you select an option in the View menu, you must confirm the option before proceeding to the next action.
Table 91. View menu
Option
iDRAC IP
MAC
Name
146
System diagnostics and indicator codes
Description
NOTE:
The display stops scrolling when the button is released. After 45 seconds of inactivity,
the display starts scrolling.
Displays the system information, status, and error messages or iDRAC IP address.
using the up arrow
> Look Up > Error Code, type the error code, and then click Look it up..
Description
Displays the IPv4 or IPv6 addresses for iDRAC9. Addresses include DNS (Primary and
Secondary), Gateway, IP, and Subnet (IPv6 does not have Subnet).
Displays the MAC addresses for iDRAC, iSCSI, or Network devices.
Displays the name of the Host, Model, or User String for the system.
is displayed.
.
Advertisement
Table of Contents
