VGA module
Remove the VGA module
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
•
Remove the front
bezel.
•
Remove the drive backplane
•
Remove the air
shroud.
•
Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the
section.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Using Phillips #1 screwdriver, remove the screw on the VGA module.
2. Slide the module out of the system.
Figure 83. Removing the VGA module
Next steps
Install the VGA
module.
Install the VGA module
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
•
Remove the front
bezel.
•
Remove the drive backplane
•
Remove the air
shroud.
Safety
instructions.
Before you work inside your
cover.
Safety
instructions.
Before you work inside your
cover.
system.
system.
Installing and removing system components
Jumpers and connectors
109