Table of Contents
Advertisement
Control panel
Remove the left control panel
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
•
If applicable,
Remove the drive backplane cover
•
Remove the air
shroud.
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Using a Phillips #1 screwdriver, remove the screws that secure the cable cover to the system.
3. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel assembly to the system.
4. Hold the left control panel assembly and remove it from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 93. Removing the left control panel
Next steps
Install the left control
panel.
Install the left control panel
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
Steps
1. Route the control panel cable through the side wall and the guide slots in the system and connector on system board.
120
Installing and removing system components
Safety
instructions.
Before you work inside your
Safety instructions
on page 52.
Before working inside your
system.
system.
Advertisement
Table of Contents
