Removing The Right Control Panel - Dell EMC PowerEdge R340 Installation And Service Manual

Figure 79. Installing the left control panel
Next steps
1. Follow the procedure listed in

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Disconnect the control panel cable from the connector on the system board.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Using the appropriate screwdriver, remove the screws that secure the right control panel assembly.
3. Hold the right control panel assembly and remove it from the system.
94 PowerEdge R340 installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.