Removing The Right Control Panel - Dell EMC PowerEdge R240 Installation And Service Manual

Figure 76. Installing the left control panel
Next steps
1. Follow the procedure listed in the

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, remove the front
4. Remove the air shroud.
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board.
2. Using the appropriate screwdriver, remove the screws that secure the right control panel assembly to the system.
3. Holding the control panel assembly, remove the control panel from the system.
After working inside your
Safety instructions.
Before working inside your
bezel.
system.
system.
Installing and removing system components 77