Table of Contents
Advertisement
Figure 68. Installing the IDSDM module
Next steps
1.
Install the MicroSD
card.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2.
Install the air
shroud.
3. Follow the procedure listed in the
LOM riser card
Remove the LOM riser card
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
•
Remove the air
shroud.
•
If installed, remove the risers.
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) riser card to the system board.
2. Push apart the two blue plastic clips securing the LOM riser card to release the riser.
3. Holding the LOM riser card by the edges, lift to disconnect the card from the connector on the system board.
4. Slide the LOM riser card towards the front of the system until the Ethernet connectors or the SFP+ are clear of the slot in the back
panel.
After you work inside your
system.
Safety
instructions.
Before you work inside your
system.
Installing and removing system components
99
Advertisement
Table of Contents
