Table of Contents
Advertisement
Table 48. Memory population rules (continued)
Processor
•
Populate all the sockets with white release tabs first, followed by the black release tabs.
•
In a dual-processor configuration, the memory configuration for each processor must be identical.
For example, if you populate socket A1 for processor 1, then populate socket B1 for processor 2, and so on.
•
Unbalanced or odd memory configuration results in a performance loss and system may not identify the memory modules being
installed, so always populate memory channels identically with equal DIMMs for best performance.
•
Minimum recommended configuration is to populate four equal memory modules per processor. AMD recommends limiting processors
in that system to 32 cores or less.
•
Populate eight equal memory modules per processor (one DIMM per channel) at a time to maximize performance.
NOTE:
Equal memory modules refer to DIMMs with identical electrical specification and capacity that may be from
different vendors.
Memory interleaving with Non-uniform memory access (NUMA)
Non-uniform memory access (NUMA) is a memory design used in multi-processing, where the memory access time depends on the
memory location relative to the processor. In NUMA, a processor can access its own local memory faster than the non-local memory.
NUMA nodes per socket (NPS) is a new feature added that allows you to configure the memory NUMA domains per socket. The
configuration can consist of one whole domain (NPS1), two domains (NPS2), or four domains (NPS4). In the case of a two-socket
platform, an additional NPS profile is available to have whole system memory to be mapped as single NUMA domain (NPS0). For more
information on the memory interleaving for NPSx, see the Memory interleaving population rules section in this topic.
BIOS implementation for NPSx
•
The BIOS Setup menu presents the applicable NPSx options based on the underlying model number. A change to the current NPSx is
communicated to pre-BIOS firmware to take effect on the next boot. The default NPS setting is 1.
•
During boot, if the selected NPSx option is not allowed for the model number (for example, if the processor model number changes
between reboot), system will halt at the end of POST with UEFI0388 message displayed. On the next reboot, the system will fall back
to NPS1 default setting.
•
During boot, if the preferred interleaving for the current NPSx is not possible due to memory configuration (for example, the memory
population is inconsistent with the preferred interleaving), BIOS shows a warning message UEFI0391.
NOTE:
System is functional when UEFI0391 message is displayed. However, the system may not be configured for
optimal performance.
NPS system optimization
Optimal system configuration is dependent on the processor model, memory configuration, and NPS settings. Match the memory
configuration with the NPS settings available for the processor.
Table 49. Supported NPS modes by Processors
Model Number
7702P
7502P
7402P
7302P
Configuration
Memory population
NPS modes supported
4, 2, 1
4, 2, 1
4, 2, 1
4, 2, 1
Installing and removing system components
Memory population
information
Optimizer population order is
not traditional for 8 and 16
DIMMs installations for dual
processor.
▪
For 8 DIMMs: A{6},
A{5}, A{2}, A{1}, A{8},
A{7}, A{4}, A{3}
▪
For 16 DIMMs: A{6},
B{6} A{5}, B{5} A{2},
B{2} A{1}, B{1}, A{8},
B{8}, A{7}, B{7}, A{4},
B{4} A{3}, B{3}
75
Advertisement
Table of Contents
