Table of Contents
Advertisement
Figure 49. Installing the heat sink
CAUTION:
Applying too much thermal grease can result in excess grease coming in contact with and contaminating
the processor socket.
NOTE:
The thermal grease syringe is intended for single use only. Dispose of the syringe after you use it.
3. Align the heat sink with the screw holes on the processor plate. The captive screws on the heat sink should align with the screw holes
on the processor plate.
4. Using a Torx #T20 screwdriver, tighten the captive screws in the order that is mentioned below:
NOTE:
The captive screw numbers are marked on the heat sink.
a. Partially tighten the captive screws 1 and 2 (approximately three turns).
b. Partially tighten the captive screws 3 and 4 (approximately three turns).
c. Tighten the captive screws 1 and 2 completely.
d. Tighten the captive screws 3 and 4 completely.
Figure 50. Installing the heat sink
Next steps
1.
Install the air
shroud.
Installing and removing system components
85
Advertisement
Table of Contents
