Table of Contents
Advertisement
Figure 86. Installing a power supply unit blank
Remove a power supply unit
Prerequisites
CAUTION:
The system requires one power supply unit (PSU) for normal operation. On power-redundant systems,
remove and replace only one PSU at a time in a system that is powered on.
1. Follow the safety guidelines listed in the
2. Disconnect the power cable from the power outlet and from the PSU you intend to remove.
3. Remove the cable from the strap on the PSU handle.
4. Unlatch and lift the optional cable management arm if it interferes with the PSU removal.
For information about the cable management arm, see the system's rack documentation at www.dell.com/poweredgemanuals.
Steps
Press the release latch, and holding the PSU handle slide the PSU out of the PSU bay.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 87. Removing a power supply unit
112
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
