Table of Contents
Advertisement
Figure 26. Removing the intrusion switch
Next steps
Replace the intrusion
switch.
Install the intrusion switch
Prerequisites
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
Steps
1. Align and slide the intrusion switch in the slot until it is firmly seated in the slot on the system.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Connect the intrusion switch cable to the connector on the system board.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
63
Advertisement
Table of Contents
