Honda Acura NSX 1991 Service Manual page 1227

5. Disconnect the cable reel harness and main har-
ness's 6-P connector, and connect the SRS test har-
ness C only to the cable reel harness side 6-P
connector.
6. Check for countinuity between the No. 3 terminal
and body ground with the horn switch pressed.
There should be continuity.
If there is continuity, the horn switch is OK.
l
l If there is no coutinuity, go to step 7.
7. Remove the TORX@ bolts using TORX@ T30 bit,
then remove the airbag assembly.
MAINTENANCE
8. Check for continuity between the horn positive ter-
minal and the steering column shaft with the horn
switch pressed.
There should be no continuity.
STEERING COLUMN SHAFT
POSITIVE TERMINAL
L
BOLT
10 N-m (1 .O kg-m, 7 lb-ft)
Replace
\