Honda Acura NSX 1991 Service Manual page 1331

-Dash Sensors Installation
CAUTION:
l Be sure to install the harness wires so that they
are not pinched or interfering with other car parts.
cracks or deformation.
For the SRS to function properly, the right and
l
left sensors must be installed on the proper sides.
1 . Be sure the battery cables are disconnected.
2. install the sensor and sensor harness.
SENSOR BRACKET
V
DASHSENSOR
MOUNTING BOLTS
22 N-m 12.2 kg-m, 16 lb-ft)
Replace.
NOTE: Make sure the sensor is installed securely.
Disconnect the short connector from the airbag con-
3.
nector and connect the cable reel and airbag harness.
NOTE: Reinstall the short connecter, then put the
maintenance lid A back in position.
4. Connect the battery positive terminal, then connect
the negative terminal.
5. After installing the dash sensor, confirm proper sys-
tem operation.
SRS indicator light should go on for about 6 se-
conds and then go off.