Table of Contents
Advertisement
Figure 114. Removing the intrusion switch module
Next steps
1.
Replace the intrusion switch
Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Align the guides on the intrusion switch module with the standoffs on the system.
2. Slide the intrusion switch module into the slot in the system until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the screw on the intrusion switch module.
4. Connect the intrusion switch cable to the connector on the rear I/O board.
module.
Safety instructions
Before working inside your system
riser.
on page 25.
on page 26.
Installing and removing system components
113
Advertisement
Table of Contents
