Installing The Intrusion Switch - Dell EMC PowerEdge T340 Installation And Service Manual

Hide thumbs Also See for PowerEdge T340:
Table of Contents

Advertisement

Figure 26. Removing the intrusion switch
Next steps
1.
Replace the intrusion switch.

Installing the intrusion switch

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Align and slide the intrusion switch into the slot in the system.
2. Connect the intrusion switch cable connector to the intrusion switch connector on the system board.
Figure 27. Installing the intrusion switch
Safety
instructions.
Before working inside your
system.
Installing and removing system components
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

E60s

Table of Contents