M.2 Boss Module; Removing The M.2 Boss Module - Dell EMC PowerEdge MX740c Installation And Service Manual

Figure 69. Installing a MicroSD card
Next steps
1 Install the IDSDM card.
2 Follow the procedure listed in

M.2 BOSS module

The BOSS card is a simple RAID solution card which supports upto 2 M.2 SATA drives. The BOSS adapter card has a x8 connector using
PCIe gen 2.0 x2 lanes, available only in the low-profile and half-height form factor.

Removing the M.2 BOSS module

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
Step
Holding the blue tag, lift the M.2 BOSS module away from the system.
96 Installing and removing system components
After working inside your sled
Safety instructions.
Before working inside your sled.