Figure 73. Installing a MicroSD card
Next steps
1
Install the IDSDM
module.
2
Install the
PEM.
3
Follow the procedure listed in the
M.2 BOSS module
The M.2 BOSS module is a simple RAID solution designed specifically for booting a server's operating system. The module supports up to
two 6 Gbps M.2 SATA cards. The M.2 BOSS module has a x8 connector using PCIe gen 3.0 x2 lanes.
Removing the M.2 BOSS module
Prerequisites
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the
PEM.
4
Remove the air shroud from the system
Step
Hold the blue pull tag, and lift the M.2 BOSS module away from the sled.
After working inside your sled
Safety instructions
section.
Before working inside your
board.
section.
sled.
Installing and removing sled components
105