Table of Contents
Advertisement
Figure 83. Removing the MicroSD card
Next steps
Follow the procedure listed in
Install a MicroSD card.
Installing the MicroSD card
Prerequisites
Follow the safety guidelines listed in
NOTE:
To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked
on the cards during removal.
Steps
Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot. To locate IDSDM/vFlash, see the
NOTE:
The slot is keyed to ensure correct insertion of the card.
Press the card into the card slot to lock it into place.
128
Installing and removing system components
After working inside your
system.
Safety
instructions.
System board jumpers and connectors
section.
Advertisement
Table of Contents
