3
Follow the procedure that is listed in
Removing the MicroSD card
Prerequisites
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the air shroud.
4
Remove the IDSDM or vFlash module.
Steps
1
Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the
2
Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Figure 63. Removing the MicroSD card
Next step
1
Replace the MicroSD cards.
Installing the MicroSD card
Prerequisites
1
Follow the safety guidelines listed in the
90
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
System board jumpers and connectors
Safety
instructions.
system.
system.
section.