Avaya S8700 Maintenance Manual page 1511

EXP-INTF (Expansion Interface Circuit Pack)
Table 8-304. Test #238 Expansion Interface Fiber Out-of-Frame Query Test
Error Test
Code Result Description / Recommendation
1033 ABORT The EI circuit pack does not have a fiber link administered to it. There is not
sufficient data to run test.
1. Issue the list fiber-link command to verify that there is no fiber link
2. If there is no fiber administered to this circuit pack, but there should be add
3. Retry the command.
2000 ABORT Response to the test was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL EI circuit pack could not detect framing sequence.
1. If the EI circuit pack that is failing Test #238 is in the PN, and the red LEDs
2. Perform the
3. Enter display errors and resolve any SNC-BD, TDM-BUS, TDM-CLK, or
PASS The EI circuit pack has detected the valid framing signal on the fiber.
1. Refer to errors from other EI circuit pack, SNI tests, or DS1 CONV tests (if
0 NO No board was detected by the test.
BOARD
1. Check the error log for wrong board (error 125) or no board (error 131).
2. Check that the board is properly translated and inserted. If so, check for
3. Run the test again. If it fails, the ID chip on board may be bad. Replace
555-233-143
administered to this circuit pack.
the correct fiber using the add fiber-link command.
are ON on a large number of circuit packs, then reseat any Tone-Clock
circuit packs in the PN.
''Fault Isolation for Fiber Links''
Troubleshooting''.
SYNC errors.
present) if the link is still not functioning.
Resolve either of these issues, if applicable.
hyperactivity (error 1538). If hyperactive, use the reset board UUCSS
command.
the board and retest.
in ''Alarms, Errors, and
Continued on next page
Issue 1 May 2002 8-789