Avaya S8700 Maintenance Manual page 1574

Maintenance-Object Repair Procedures
Table 8-328. Test #759 Configuration Audit — Continued
Error Test
Code Result Description / Recommendation
140 FAIL The Endpoint 1 SNI is physically connected to a DS1 CONV but is not
administered to be connected to a DS1 CONV. (The list fiber-link command
displays a fiber link's endpoints.) Either add the DS1 converter complex to the
fiber that this SNI is associated with by:
1. Check for the fiber that this SNI is an endpoint of by checking list
2. Remove fiber-link for the fiber that this SNI is an endpoint of.
3. Add the fiber back via add fiber-link and this time administer the DS1
202 FAIL The SNI circuit pack (Endpoint 2) cannot communicate with the equipped SNI
in slot 2. (The list fiber-link command displays a fiber link's endpoints.)
1. Perform the
2. If the SNI being tested has SNI-PEER Error Type 1, replace the SNI being
3. If the SNI being tested still has SNI-PEER Error Type 1, replace the SNI in
203 FAIL The SNI circuit pack (Endpoint 2) cannot communicate with the equipped SNI
in slot 3. (The list fiber-link command displays a fiber link's endpoints.)
1. Perform the
2. If the SNI being tested has SNI-PEER Error Type 257, replace the SNI
3. If the SNI being tested still has SNI-PEER Error Type 257, replace the SNI
8-852 Issue 1 May 2002
fiber-link.
converter complex also. Or, remove the DS1 CONV connection and
connect the SNI directly to its administered fiber endpoint by entering list
fiber-link and verifying that the fiber-optic and metallic cable connections
are installed as administered.
''Fault Isolation for Fiber Links'' on page
resolve multiple SNI-PEER errors.
tested. (Replacing an SNI may be service interrupting. Refer to the
SNI-BD section for the procedure to replace an SNI.) To view SNI-PEER
errors, use the display errors command with category PNC-PEER. Retry
the command.
slot 2.
''Fault Isolation for Fiber Links'' on page
resolve multiple SNI-PEER errors.
being tested. (Replacing an SNI may be service interrupting. Refer to the
SNI-BD section for the procedure to replace an SNI.) To view SNI-PEER
errors, use the display errors command with category PNC-PEER. Retry
the command.
in slot 3.
4-19. This should
4-19. This should
Continued on next page
555-233-143