Play Mode - Omron SYSMAC C200H-OV001 Operation Manual

PLAY Mode

3-4 PLAY Mode
Playing Back Messages in PLAY Mode
Connecting Output Devices
Set the mode selector to
PLAY
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Start
Connect an output device
(speaker or amplifier) to the
Voice Unit. (A recorded mes-
sage can also be monitored via
the built-in speaker.)
Set the line/speaker selector
switch to match the connected
output device.
Set the mode selector
switch to PLAY.
Select a message number
with the MSG No. increment/
decrement switch.
Push the ST/SP switch to start
message playback.
Adjust the output level with
the output volume control.
To interrupt playback, push
the ST/SP switch again.
End
Messages can be played back in PLAY mode and ON-LINE mode. In PLAY
mode, messages are played back according to the manual selections the
user makes. In ON-LINE mode messages are played back according to the
program.
This section describes playback in PLAY mode, which is the simpler of the
two modes.
(To playback messages in ON-LINE mode, refer to 3-8 ON-line mode .)
Messages can be checked with the built-in monitor speaker, however to
check the volume and sound quality of the messages connect an external
speaker or amplifier to the message output jack of the Voice Unit. (For de-
tails, refer to 1-3 Interface.)
Set the line/speaker selector switch to match the connected output device.
Set the switch to the L position when an external amplifier is connected. Set it
to the speaker side when a speaker is connected.
When the Voice Unit is ready for playback, the PLAY indicator is blinking at
0.5 second intervals.
Section 3-4
25