Omron SYSMAC C200H-OV001 Operation Manual page 15

Nomenclature and Functions
Switches, Controls, and Jacks
Switches and controls
MACHINE No.
ON LINE
PLAY
REC
Mode T
Selector
ERA
XMT
RCV
MSG No.
MSG No.
ST/SP
IN-VOL
OUT-VOL
L MIC
IN
L
OUT
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Sets the Voice Unit system configuration unit number to any integer between 0
and 9. Do not set the unit number to the same as that of another Special I/O
Unit in the configuration. If this is done an "I/O UNIT OVER" error will occur.
Note 1. Before setting this switch, be sure to turn OFF the PC power.
2. Set this switch with a standard screwdriver and be sure to set the
switch completely.
Voice Unit operation is controlled by the PC.
Recorded message playback mode.
Message recording mode.
Remaining recording time display mode. The remaining time is displayed on the
MSG No. indicator LEDs.
Recorded message erasure mode.
Recorded message transmission mode. Transmission to external devices (FIT
etc.) via the RS-232C link.
Message receive mode: from external devices (FIT etc.) via the RS-232C link.
Note 1. Set the switches correctly, if set incorrectly the Unit to error.
2. Do not set the switch to the position between RCV and ON LINE
mode (this position corresponds to no mode and causes the Unit to
error).
Pressing this button once increments the message no. by one (holding this
button down causes the message no. to increment successively ).
Pressing this button once decrements the message no. by one (holding this
button down causes the message no. to decrement successively ).
Starts and stops operations in PLAY, REC, ERA, XMT, and RCV modes.
Adjusts the microphone or tape recorder message input volume level. Turn
clockwise to increase the volume and counterclockwise to decrease the volume.
Use a screwdriver to adjust.
Adjusts the speaker message the output volume level. Turn clockwise to
increase the volume and counterclockwise to decrease the volume. Use a
screwdriver to adjust.
Selects input message source. Set to L to input messages from a tape recorder
and to MIC to input messages from a microphone.
Microphone or tape recorder input jack (designed for a 3.5 mm mini-plug).
Selects output device. Set to L to output messages to an external amplifier and
to the speaker symbol to output messages to a speaker.
External amplifier or speaker output jack (designed for a 3.5 mm mini-plug).
Function
Section 1-1
5